![Hardlock Driver Etka Hardlock Driver Etka](/uploads/1/2/6/3/126378577/969794979.jpg)
How to install VW ETKA 7 5 electronic catalogue. Step 1 - install Hardlock device driver. Copy ETKA 7.5 zip file from dvd disk to local disk D: Then extract Etka 7.5. Open folder ETKA- QQ1 to install hardlock device driver 5.22. Step 2 - delete dl file. Copy LexHd5.dll from D:/ ETKA to C:/WINDOWS/system. Step 3 - install Hardlock emulator.
Free download ETKA 7.5 Windows 7 64 bit:
IMPORTANT NOTE- if you don’t wanna take any risk to use VW ETKA 7.5 and hope it never expires, you can use the tested ETKA 7.5 spare part catalogue:
(ETKA 7.5 available only via Skype: http://www.obdexpress.co.uk/)
How to install ETKA 7.5 Windows 7 64 bit:
- Execute the following commands from the command prompt with full administrative rights:
bcdedit.exe /set nointegritychecks ON
bcdedit.exe /set TESTSIGNING ON
Each command should receive a successful execution confirmation.
- Reboot the computer. Now you should see a “Test Mode” watermark in the lower right corner of the screen.
- Edit the registry by running “0000750A.reg” from the “MULTIKEY64” folder.
- Run “INSTALL.CMD” from the “MULTIKEY64” folder. Lack of error messages would indicate successefull driver installation.
![Hardlock Hardlock](http://blog.uobdii.com/wp-content/uploads/2017/04/audi-vw-seat-skoda-etka-electronic-catalogue-1-1024x476.jpg)
- Run “hardlock.EXE” from the “Hardlock” folder.
- Reboot the computer.
Should you have any problems deleting the earlier instance of the multikey driver:
- Run “REMOVE.CMD” from the “MULTIKEY64” folder. Lack of error messages would indicate successefull driver deletion.
- Run the “infclean64.exe” utility from the “infclean05” folder for the final clean-up.
You can turn off the test mode but in this case you will need to disable Driver Signature Enforcement.
You can get rid of the “Test Mode” watermark by running “RemoveWatermark 7 X64.exe”.
Should you run into a problem in step 4 you can implement the advice provided by andy040670:
- Start the Device Manager => right click the root directory => pick “Add
legacy hardware” => “Next” => “Install the hardware that I manually select from
a list (Advanced)” => “Next” (don’t pick anything) => “Have Disk…” => point to
the MULTIKEY64 folder => OK => agree to install the non-signed driver.
This are old an instruction but still work well. Credit to original author
This are old an instruction but still work well. Credit to original author